Home /
Applying a mask from activated charcoal and gelatin
;

Applying a mask from activated charcoal and gelatin

There are two main recipes for gelatin masks with activated charcoal. One of them is prepared with the addition of water, and in another version, milk is used. The second recipe is most preferable because in this case, your skin gets extra nutrition. This is what we will consider in more detail. Mask composition: Gelatin […]

Applying a mask from activated charcoal and gelatin

There are two main recipes for gelatin masks with activated charcoal. One of them is prepared with the addition of water, and in another version, milk is used. The second recipe is most preferable because in this case, your skin gets extra nutrition. This is what we will consider in more detail.

Mask composition:

  • Gelatin food – 1 tsp;
  • Activated charcoal – 1 tablet;
  • Milk – 1 tbsp.

First, you must thoroughly crush the coal and interfere with dry gelatin powder. After that, add warm milk and stir well. Now the crucial moment has come – the liquid needs to be slightly heated, but so that it does not boil. This can be done in two ways – in a microwave oven and in a water bath. Carefully follow the process, usually, only a few seconds are required to dissolve the gelatin. After that, make sure that the mask is not too hot and use it for the intended purpose. Keep reading http://www.beavertonschoolofbeauty.com/laser-resurfacing-treatments-improve-look-feel-skin/

If you do not have the opportunity to add milk, then you can replace it with the same amount of ordinary clean water, mineral water or herbal decoction.

Rules of the procedure

To make the activated charcoal skin care mask work as effectively as possible, prepare the skin. With it, you need to wash off all makeup, and ideally also steam out. The mask should be applied in two doses exclusively to problem areas, in no case touching the area around the eyes. First, you need to take a small amount of the drug and use your fingertips to drive it into the skin. After the first layer is slightly dry, the second layer should be applied from above.

Now you just have to relax and wait until the mask is completely frozen. This usually takes about 20 minutes. Do not make any mimic movements at this time.

After the film has completely solidified, gently remove it from bottom to top. Do not wet it, otherwise, the effectiveness of the mask will decrease, and it will be difficult to remove it.

Completion of the procedure should be a narrowing of the pores and moisturizing. To do this, wipe your face with a toner, and then apply the cream. It is best to perform all actions in the evening, closer to sleep.

The optimal course duration

Mask of gelatin and activated charcoal has long won universal appreciation. Numerous positive reviews indicate that the results are palpable from the first application. However, in order to achieve maximum effectiveness, it is necessary to undergo a full course of procedures, which is from 1.5 to 2 months, depending on the initial condition of the skin. You only need to do the mask once a week.

Gelatin mask-film with activated charcoal is an excellent substitute for expensive cosmetics and strips from black dots. Regular application of it will clear the skin, eliminate wrinkles and normalize the fat balance.

Leave a Reply

Your email address will not be published. Required fields are marked *